Yet another re-winder for XYZ DA Vinci printer updated

Update:
One of the issues I have found with the re-winder is that the spool has a tendency flex out at the outer edges of the spool the issue is that it binds inside the cartridge
This version the brown one helps hold in the sides of the spool while you are filling it
I have updated the plate for this you use the same part for both sides assembly is basically the same

After having to modify the one with threads by drilling out and putting in a nut and bolt.
So here's my version.

Other Parts you will need to assemble
QTY 1: 1/4" Carriage bolt, 4" long
QTY 1: 1/4" Nut
QTY 1: 1/4" Wingnut
QTY 2: 1/4" ID, large OD fender washer

Instructions:
If the instructions are lacking check the photos.
This is yet another XYZ Da Vinci spool re-winder. This one uses less filament.
Print both pieces. I recommend printing excellent at 50% fill.
They are already for printing, and no supports needed.
Remove the spool from inside a Da Vinci cartridge
Place a 4" long, 1/4" bolt, through driver side and press the carriage bolt into the square hole. Place washer on bolt then tighten with nut.
Place this assembly through spool.
Slide re-winder end part on bolt add the washer and wing nut.
Use end of bolt into an electric drill, and use it to wind filament onto the spool.

Also note in the diagram how to wind from one spool to the other to avoid twisting