Monstrous Creature Base 120mm x 90mm

120mm x 90mm large monstrous creature bases; primarily used for a new Tyranid army. Scale as needed; could work well as scatter terrain. Add as much flock, grit/sand, body bits and slime to your hearts content... prints without support;

The bases are entirely flat on the bottom without the customary raised indentation. A raised indentation could be added to allow pins to extend below the base or weights to be added underneath however it would then require supports to print. I've pinned models directly to the raised terrain areas on the base - rocks, side walls, eggs, et.al. Use a small pin drill to create a hole where you need and add a few drops of super glue in the hole before inserting the pin.