Vertex k8400 Hood enclosure (Remix)

This is a remix of Emil Hallgrens Hood enclosure. I wanted to not use any screws on the frame and i modified it to be able to handle my PI holder on the right side of the printer. I also put in a lid on the design and gave it hinges and a handle bar.

The top brakets is glued on the 4mm Acrylic making it a frame the bottom brakets is attached the same way as Emil's is.

The height of the acrylic is 22cm the width might need to be amended for your printer in my case back is 38,5cm and the sides top is 38cm and bottom 37,7cm the lid is 36,5x36,5cm.

The back acrylic have a 12mm cutout at the bottom 9,7cm in from both sides.