Cardboard VR easy to print easy to assemble

I know there are many great designs out there, but some are hard to make, others are too flimsy, others require supports, screws and other stuff and I've made a design that requires 0 support, 0 screws and it's easy to print.

The only thing you need is a bit of glue and 5 minutes of assembly.

It's to be used with 25 mm diameter 45mm focal lenses available on either ebay or aliexpress.

For the hinge mechanism use PLA or ABS filament of 1.75mm. To hold the phone in place use rubber bands. It is made to fit most phones and I didn't design a proper lock mechanism due to different phone sizes.

It should take about 12 hours of printing on most printers or a bit more depending on your settings. I use 0.2 layer height and 30-35% infill.

Important note: Please be aware that this case is suited for phones up to 5.1 inches. If it's bigger than 5.5 inches it will exit the case a bit and the top part of the screen will not be fully viewable.

Enjoy.