Sub33D v2.06 sub $100 AUD recycled e-waste 3D printer

Please check out new and cheaper $65 Sub33D 2.07 version with improved x-axis motor and idler mounts:
http://www.thingiverse.com/thing:1429273

Please check out video:
https://www.youtube.com/watch?v=YkrMPGtMW3M

Sub33D v2.06 sub $100 AUD recycled e-waste 3D printer
Print area 200W x 200D x 180H
High accuracy long life 604/605 bearing construction (No linear bearings)
10mm rods throughout design (stiffer, less vibration)
Ridged frame design (minimize frame flexing)
Designed to utilize recycled printer, PC and general e-waste components supplied by Substation 33
Component cost excluding recycled components under $100 AUD

Main purchased components:

• Electronics (Mega, Ramps, LCD, etc)
• Hot end
• Heat bed
• Threaded rod and small number of screws and Wade Extruder bolt
• Printed parts approx 0.5kg

Main recycled components:

• 8mm acrylic sheets from PC LCD monitors
• 10mm chrome steel rods recovered from office printers
• Nema 17 stepper motors recovered from office printers
• ATX 350W PC power supply
• screws, rubber bushes, heat sinks, fans recovered from office printers and PC's
• 16mm laminated particle board base plate recovered from old kitchen cabinet
• Heat bed glass recovered from office printer
• Wiring recovered from Ethernet LAN cable (multi stranded wire, not solid core) and PC power cords (10A wires)
• Bearings recovered from office printer stepper motors (non Nema type stepper motors)

Built and filmed on location:

• Substation 33 (www.substation33.com.au)
• 31 Mary St, Kingston QLD 4114, Australia
• Ph +61 (07) 3826 1533

Please check out the following Youtube video build sequence play list for detailed build instructions (still under construction):

https://www.youtube.com/watch?v=0eCutGJ9l7U&list=PLW8e88EbKrS9L1Py1hJ-ydUP7O0o1GQaK