New version available: Please go check the new model
Ultra Flat Filamentholder which is updated to be 8mm lower, be more accurate and print faster :)
----
Features of the Flat Filament Spool Holder
- 6. juni. Finally finished making it. Enjoy :)
- Quickrelease with simple fingernut
- Very smooth spoolmotion with wellplaced bearings supporting the spool on 4 points.
- No special tools, screws or springs needed
Parts Description
**2x-quickrelease-no_springs** This part consist of 2 parts but is printed in one go. There is room for fingernut on the rear end, which presses down on the break-away lower part of this piece. The lower part is then pulled upwards and together they squeeze tight on ..
**4x_pulley-flanged_bearing.stl** This is the pulleys where you put *2x flanged bearings* into each.
**2x_lower_mount_points** Added internal spacer for the *F608zz bearings*. It's slightly higher than the bearing to provide smooth runnings.
**Spacers** I included a few different spacers to make sure you had something fitting your printer.
Bill Of Material
- 4x 20mm m3 sccrews.
- 2x 35mm m3 screws.
- 10x m3 nuts
- 8x F608ZZ bearings
BOM - specifed
- Quickrelease each: 1x 20mm m3 screw. 2x m3 nuts. 2x F608zz bearings
- Fingernut each: 1x 20mm m3 screw. 2x m3 nuts.
- Lower Mount Points each: 35mm m3 screws. 1x m3 nut. 2x F608zz bearings
- Mounting bracket (Holder): 3x 12mm scrwes. 3x m3 nuts.
Link to show the
F608ZZ bearings from RobotDigg 
dintid
