Nitecore MH20 Ninjaflex, TPU, Jacket

The purpose of this creation is for extra protection. The flashlight will not get scratched up if it's in your pocket with your change or keys. If the flashlight is dropped while in use, it will provide some protection from dents or scratches. It will keep your expensive flashlight looking new years from now.

Now that I have created a 3D replica of the flashlight. I may design more accessories for this flashlight if there are any requests for it.

Design elements:

• Three piece design for easy access to battery and open area for heat dissipation
• Good protection inside or outside of your holster and while in use
• Soft material that feels good in the hand
• Fits like a glove
• Access to the USB port

Note: I've printed and tested this sleeve on ninjaflex material only. I have not tried it with TPU or other flexible material. While it is relatively easy to put the sleeve on, it is much harder to take it off. I had to use a vice and pliers to take it off. As a last resort, you may want to cut the sleeve off. Disclaimer: I am not responsible for any damage you may have caused to your flashlight during this procedure.