Another parametric customizable stand for my parametric bottle tray

This is another customizable, parametric stand for my bottle trays. The advantage of this one over my other design is that it's quicker to print (it takes about 60% less time) The disadvantage is that it takes up a bit more room and may not fit your print bed. By default, the legs are 10mm square so the outside dimensions will be 20mm larger than the inside. If you made a tray which is more than 180mm wide and your print bed is only 200 mm then it won't fit. My other design only added 6mm to the width (with default wall thickness of 3mm).

There isn't much to input, just measure the dimensions (width length and height) of the object that you want to be able to put underneath and add a couple of mm for clearance. Alternatively, measure the size you want the top to be and take off 20mm (or twice whatever size the legs are) which will give you the inside dimensions.

You can change the size of the legs but the default is 10mm and should be fine (and they are hollow to sped up the print time).