March 27, 2016
Description
This is a remix of clough42's Itty Bitty Belted Extruder using a Nema17 rather then a Nema14 motor. All other parts are carried over. I used his build instructions as these are very similar
The recess in the bottom is designed for a e3d v6 hot end. I do not have one yet but will this week. Until I test fit it I'm marking this as a work in progress. The images are from the first printing I did where I forgot to include this recess.
Its designed to work with 1.75 filament. I added an additional model for .3 filament but as I do not run this I will not be able to test it.
I designed a mount to work with a V-Slot mini Gantry : http://www.thingiverse.com/thing:1449705.
I did not change the geometry from the Itty Bitty Belted Extruder so any mount that would work for that should work for this.
I designed it so the same 188gt2 belt can be used. It's tight but fits. I extend the adjusters so any belt from 188 to 200 should work.
You can read more about the Itty Bitty Belted Extruder here : http://www.thingiverse.com/thing:389105
Added two additional versions :
Not_So_Itty_Bitty_Belted_Extruder_With_Top_Chain_Mount.stl - Provides mounting locations for a cable chain.
Not_So_Itty_Bitty_Belted_Extruder_30.stl - 3mm filament
I have an alternate guidler that I'm running now here : http://www.thingiverse.com/thing:1460827
License:
Creative Commons - Attribution - Non-Commercial
buffcleb
