Pergo Kitchen Aid Mixer Top or Cover

For the KitchenAid KSM150 5QT Bowl

By Popular Demand: I created a "Connector" for small printers so you can slice the top into two parts and print on a small printer. Print the connector on its side. I oriented the connector so that the Thingiverse preview would allow you to see what it does.

The Wife just loves the stand mixer I got her. It does everything for her, but only has one top.
"you know that expensive printer you got, Let's see how good you are with it....?"
So I produced, this, and got a big kiss!
Maybe you too can get a big kiss from your wife. If you do let's see the "make pics"
Not the "Make out pics"! :P

Print 100% infill
NEEDS!! Supports "Touching Build Plate"
.3 Layer is great.
I did use PLA as this item does not get so hot and it's an easier print.
Recommend ABS or PETG so it survives the dishwasher's 170 F (76 c) temp. Because of the ridges, I recommend that ALL food items be sprayed and sealed with this silicon spray and then give proper time to thoroughly dry. (give it a day for safety)

http://www.amazon.com/MG-Chemicals-Silicone-Conformal-Coating/dp/B008O9YGQI

One can is enough to do .... well I have not yet went through a can yet. I guess that you can get about 100 decent sized prints in one can.

Cleanup, bust away the supports. I cleaned the inside supports with a dremel small wire wheel medium speed and not much pressure while moving back and forth lots.