Sub 30$ 3D laser scanner REMIX for large 3d printers

Importand: this is just a remix of Farretis 3D Scanner all credits belong to him.
see: http://www.thingiverse.com/thing:702470

Its just a different set of STLs for those with large 3D printers.

It summarizes the 3D printed parts to just two, with almost no screwing necessary (basically push fit of lasers and camera).
It requires a build volume of at least 295 x 290 on x and y and a z-height of at least 160 mm.

There are internal channels for hidden wiring of the lasers (use a short piece of filament to guide the wires through the channels.

IMPORTANT:

• the mount is for linear lasers with a diameter of 9 mm.
  Just google for "LFL650-5-12(9x20)90"
• it uses 3 ballbearings with dimensions 10x5x4 mm (OD, ID, width) that are screwed to the base with 3 sets of M5x16 screw, M5 nut and a washer each

For all electronic parts, software and further instruction please see Ferretis original thing at http://www.thingiverse.com/thing:702470

Update: added mySub30large_tableHigh.stl thats an alternative to mySub30large_table.stl just with the table surface raised by 20 mm