Jumper 260+ quad conversion parts, New arms, FPV transmitter holder, Sony CCD camera conversion + misc

The new arms are designed to hold the ESC with just friction and a small dab of hot glue (no zip ties needed!) they also have an expected failure point (by design) at the posts to avoid transferring a hard impact onto the mainboard, built in 28mm motor guards. Note: These arms will also work with littlebee 20amp escs as they are the same width as the stock bhheli long 20amp escs with the jumper quad.

FPV transmitter is hot glued in with 1 or two zipties over top to keep it pressed down in the event of a hard crash. Keeps east access to dipswitch to change channel.

The new tilt mount holds the ever so popular sony CCD. Designed it to cradle the board as much as possible since the jumper frame provides 0 protection to the camera. Captures a standard nylon lock nut inside the case to tighten the camera on the pivot points.

Cone legs and antenna brackets are untested but no reason they won't work. Several mounting positions for the cone legs the screw in, you could thread right into the plastic or drill out for brass thread inserts if you prefer.

All of my parts use m3 machine screws and nuts, so you will need to drill out any of the mounting holes used with a 3mm bit or tap it with a 3mm tap to mount these parts.

Note about weight increase, with arms, transmitter bracket, sony ccd plus printed mount and receiver is 405g about 65 grams heavier than the kit with original pieces and no receiver. The 28mm motors with 6" props have 0 issue with that.

Side note about transmitter and camera connections, do yourself a favor and rip those junk ports off the board and replace them with servo leads if you haven't already