Filastruder Electronics Enclosure v3 & Hopper Funnel v3 (Based on the original by Tim Elmore)

I added "Filastruder", "MAIN", "MOTOR" script to the front panel, vents along the top, angled support for front panel. As well as a screw down tab on the left side.

This holds down the Sestos controller perfectly no need to fasten it to the Enclosure or the wooden support.

Fits #8 screws on all holes (I used the same diameter screw holes as Tim's design). I did remove the front right upper hole as I was not sure the purpose of it.

The Hopper has a tapered bottom, instead of being flat.