75mm VESA Box and Plate

This is tagged as a remix because the hole positions are repurposed from 0110-M-P's RasPI case mounting holes for 75MM VESA mounting and is based on the MP Select Mini Mount designed by j4c3 and was created in Tinkercad.

The Project box comes with two holes pre-fabbed for mounting the quad-relay board on Amazon (Just search four relay board raspberry pi and you'll find it). Other than that, the walls and lid are left blank to provide the most flexibility when it comes to cable routing.

The box features eight captive bolt slots (#6 nuts and bolts are used in the attached pictures) and is designed to have some strength to it to hold the bolt in place while the screw is tightened. That being said, don't go all hulk on it and try and apply 50ftlb of torque on the screws. Little bit tighter than hand tight will give you good solid connection.

This is my first project from conception to print and I'm pleased to say that I've been met with some level of success. Just ignore the fact that it looks like Cthulhu is holding the nuts in place.