Azteeg X5 Mini V3 40mm extrusion mount.

This is a mount for an azteeg x5 mini for openbuilds 40mm vslot extrusion (2040 or 4040).

Use m5x10mm screws to attach to extrusion. Use m3 x 12mm to attach board to mount. (In the photos, I used arduino washers and m3 x 16mm)

9/3/2016 - rev 1.5 - I adjusted fitment of the ports. I also shrank it down to 32mm total height. To achieve this, I could only allow for 2 mounting screw holes. I also added nut traps at the bottom, with a .25 mm support layer.

9/4/2016 - rev 1.7 - I added the open hardware logo and some little 5x5mm extrusions for zip ties.

9/4/2016 - rev 1.8 - I added some more 5x5mm extrusions for zip ties for the 3 screw terminals on the left side of the board.

8/6/2016 - This is pretty much complete for now at rev 1.8. I added some photos. Ill add more when I am done, to show how I intended this thing to be wired up.