Foldable Handle (Print and Play) For Lab ATX Power SupplySkeleton Case

I was impressed by the james_III's design : Lab ATX Power Supply Skeleton Case. only the Handle bugs me, so as usual... I've fired my brand new freecad 0.17RC (time to start learning the new part design next workbench :) )... And here the result!

This Handle is design to be print on the side without any support... printed at 0.2, 20% fill... pop it up from the bed, screw it in place and Enjoy!

I've also Attach the freecad file... have fun :)

Special thanks to MasterG403 for result picture and test!

PS. Since the pivot is a ~1 cm bridge the hinge would be a little hard at start but it take not time take its place...