Basic scratch-built gunpla stand
Features:
- Theoretically cost-efficient over most basic gunpla stands in the market (calculated using mass properties in SOLIDWORKS and assuming <$20 filament)
- Supports RG and HG models, although the rectangular mount for RGs is not ready yet
- Can hang on walls using the little cutout behind the base part
For full assembly instructions, proceed to this link: http://www.instructables.com/id/3D-Printed-Gunpla-Stand/
Revision 1 (10/21/16, 9:52 PM PST):
- Added the rectangular mount for those that require it. My print settings had it at 80% infill
MechaDane
