Arduino Leonardo slim case with mounting tabs

Just added some mounting tabs to this already excellent project. I found that the studs going through the holes in the Leonardo PCB were just ever so slightly too tight, so I had to cut them just a tiny bit down to get a good fit all the way around. Also, there is a big decoupling capacitor behind the power connector that is blocking for the lid to properly close because of the "cut-out walls" around the analog pin connector.
So if I were to print this again, I'd tweak the design further by shaving 0.2mm off the PSB support studs and make a cutout for that big capacitor.
Apart from that, this is a great design from the original designer, kudos! Love the little reset button.

Prints with no supports, used normal settings on Ultimaker 2+.