DAILEY 16

This is the "DAILEY 16", inspired by the R/C 10.

This took about 300 hours to design, I started this project back in March of this year.

I have printed and test driven 2 cars with the parts currently uploaded... this is a complete Kit.

               Parts List For The "Dailey 16" R/C Buggy
          This Kit Uses Parts From An "ECX 1/18 SMASH" R/C Truck.                                                           

                                                                                      
       

1. ECX8326 Front Shock set 1

2. ECX8327 Rear Shock set 1

3. ECX8329 Hinge Pin set 1

4. 2mmX4mm long Screw 30

5. 2mmX6mm long Screw 30

6. 2mmX10mm long screw 20

7. 2mmX12mm long screw 1

8. 2mm Nut 4

9. 4mmX7mmX2.5mm bearings(MR74ZZ) 10

10. ECX ECX8312 Transmission Set 1

11. ECX ECX8321 Spindle, Carrier, & Hub Set 1

12. .5 Mod 16 Tooth Pinion 1

13. ECX8320 Driveshaft & Axle Set: Smash 1

14. 1mm(.039") Piano Wire For Tie Rods And Servo Link. about 8" long.

---

Shock_Spacers.STL part is for controlling the travel on the FRONT AND REAR shocks.
The spacer slips over shock shaft, INSIDE the shock. The shocks need to be disassembled to install the spacer. Use a paperclip to push out the top retaining pin, and pull off the top of shock. Unscrew the shock shaft with a small Phillips screwdriver. Then slid off the rubber bump stop, slide the Shock Spacer on, and reinstall the bump stop. reassemble the shock in reverse order.

The Dogbones need to be shortened to 28mm pin-to-pin length. Use 2mm ID brass tubing, and silver solder together.

11/9/2016 UPDATED .STL FILES ARE NOW POSTED IN METRIC UNITS

No changes where made to the models.

UPDATE 11/12/2016

Changed the rear body post, and added a front body post.

UPDATE 11/13/2016

Changed rear rims for more thread engagement when using Nylon locking nuts.
Also, use the shock spacers on all 4 shocks for proper stance, and elimination of bump steer on the front suspension.