Mosfet & mainboard support frame for Anet A8

UPDATE:I uploaded a small, mini and micro version, basically, the only thing that matters is the bridge between the mainboard mount and the mosfet. If you use 4 the white washers that are originally used to mount the mainboard, on the upper side of the mainboard and the lower side of the mosfet, you're good to go. Faster print, less wasted plastic.

Needed a frame for my mosfet board on my Anet A8. I thought The original design (1857006) was a bit wasteful, both in print time and plastic, since the design aspect would be completely covered by the actual boards anyway. Hence this design, which saves +/- 50% of time and plastic. I actually designed this from the ground up with Adobe Illustrator and Blender, but i did use Sjouke's file for measurements.

How to connect the mosfet board: https://3dprint.wiki/reprap/electronics/heatbed_mosfet