Rostock max clip on T10 LED

Used the clip shape from the LED mount created by int2str, but redrew it to fit T10 LED bulbs. These 5630 LEDs are very bright, seem to run fairly cool, and the mount is low profile. Solder leads to the back of the bulb before installing into the housing. Exits for the wires to the inside and out both sides. I just drilled a small hole next to the extrusion to pass the wiring through. Best printed in TPU, could work in other materials but I haven't tested fitment except in TPU. I drew them to use on my Rostock max, but should work equally well for any other 1"aluminum extrusion.

You can find the LED bulbs I used here (not an affiliate link)

These bulbs have bridge rectifiers on them so it makes no difference which pad you solder positive or negative to.