December 3, 2016
Description
This is heavily based on http://www.thingiverse.com/thing:863076 but is a complete rework and redraw to accommodate an 80mm fan, more ventilation slots and 5mm more height.
Other changes include the square 'hoops' along each side to cable tie cables to, the 12mm high standoffs, 3mm mounting bolts holes (recessed to prevent short circuits) increased size of the M3 nut holders and larger cable exits.
10/12/2016 - I uploaded an alternative back end for the box as this one gives better ribbon cable access for the LCD display and cable access generally.
30/06/2017 - I've uploaded a new set of sides. These are 15mm taller than the originals to allow more electronics to be crammed into the RAMPS case. They are identified as v1.6 (taller) in the file listing.
Other parts designed for my printers include:
For avoidance of doubt, this item is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. See http://creativecommons.org/licenses/by-nc-sa/4.0/ for more details.
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
RGN01
