Hubsan H501s Drone Quadcopter legs

This is clip on legs and carry frame for the Hubsan H501s quadcopter / drone. Once assembled it simply clips on. The frame can be used to carry extra cameras, batteries, radios, lights, etc. And the legs keep the propellers out of the grass.

I printed this is PLA and the leg ends in rubber. Print the legs separately lying down. then glue the legs into the frame holes. The frame side with the little "knob" is at the front. it's a little shorter at the back to miss the battery door. I use the two side tabs on the frame to tie on a downward looking camera.

So far, the carriage has survived a few "unoptimal" landings. But hey - easy enough to print another if it breaks. I went for lightness rather than weight.

Anyway - the design was done in OpenScad (with no apologies for the rotten coding!) so you can adjust to meet your specific needs.

10Jan2017 : Added separate STL files and alternate leg in case you want the frame on the bottom.