Upgraded clip for round build plate (200mm)

This design is loosely based on Thinner42's glass clamp.

It fits on an AnyCubic Kossel delta printer with a 200mm diameter print bed. It should work on any printer that uses extruded 2020 aluminum as a frame. These clips hold the glass very securely and don't allow for any movement.

I have also created a 240mm variant, this is untested, and have been told that it does not actually fit. I'm working on a redesign.

You will need the following for each clip:
3 x M4x8mm
3 x M4 square nut.

(For all 3 clips you will need 9 of each)

I have had succes sprinting this design without any support. There is one small hollow in the larger component, but my printer was able to print it.