January 29, 2017
Description
This is my 2nd project in 3d modeling, using both Autodesk 123d and Autodesk Fusion 360
Again, there are many similar Things to this, but this is a design from scratch object.
You will definetely need to enable supports and a little carefull cleanup after words is necessary. I've split the hoop twice in my rush to remove the supports, go easy.
A decent infill would help, and i don't see why you can't just print at 100% infill, the diffenence is only 1.5mins printing time 13.5 vs 15 mins, and 20cms of filament.
I've also included my v1 filament guide which needs no supports to print, but is a solid hoop, i cut a section out of mine to allow side entry for the filament which led to the v2.
Prints fine in Cura 2.3.1 or using Cura slicer from Repetier, print speed about 55mm/s, 0.2 layer height, 40% or higher infill
License:
Creative Commons - Attribution
wolfsbaine
