Eton Traveler Stand

Stand for the Eton Traveler Radio

I have had problems with the radio falling over due to its thin base and decided to build a stand.
The stand is easy to print.
I printed the stand in eSUN PEGT but I'm sure the tolerances will be fine for PLA.
The radio fits snugly inside the Radio Holder and can be angled for viewing comfort.

Assembly

To assemble 2X washers go on the outside of the Base and two go inside between the Radio Holder and the inside of the Base to prevent plastic on plastic contact at the pivot point.
Then tighten the nuts till tight and the desired resistance is met to hold the Radio upright.

Hardware
4X-1/4" washer
2X-1/4" nut
1X-1/4" threaded rod 6.2" long

I printed both parts with 3 perimeters using a 0.4mm nozzle 20% infill
Support is needed for the Radio Holder part to print.