Tactical X Carriage

Print at .2mm layer height and .4mm nozzle width.
Infill doesn't have to be more than 20% even with PLA for good performance. Heavier carriage will induce more 'ringing' artifacts, so no need to over do it.

https://youtu.be/lC0DSHMy9x8
https://youtu.be/GrBnLkITbCA

Fantasic video of assembly and installation: https://www.youtube.com/watch?v=B0B2--2LZ9k

• big thank you to GeorgesGadgets for putting this together!

Features

• Lightweight
• Easy to print
  • No supports required
• Multiple hotends supported
  • Chimera/Cyclops
  • Stock Tarantula hotend
  • E3D V6 Genuine/Clone
• Quick-swap
  • switch hotends in seconds
• Stock V-wheel or MGN12 rail
  • Makes it easy to start with V-wheel and upgrade to rail
• Clean wiring solution
• Integrated layer cooling
  • Using blower fan for higher pressure
  • Two options for fan placement
  • Swappable duct for experimenting with different designs
• BLTouch mount
  • Nozzle offset kept same for various hotends - spacer available
• No modification to stock frame or settings needed
• Does not affect available print volume
• Minimal vitamins needed
  • JST RCY 20AWG Prewired Connectors
  • Machine screws
  • Brass knurl inserts
  • 2.54 Pin Headers

UPDATE 1: Adding assembly illustrations
UPDATE 2: Adding version 1 files for carriage and E3D V6 mounts w/BLTouch
UPDATE 3: Adding version 1 files for E3D Chimera/Cyclops mount w/BLTouch
UPDATE 4: Adding drag chain support shelf and new simple layer fan duct
UPDATE 5: Adding carriage base version for MGN12 (H or C) linear guide (can also be used with stock v-wheel setup)