Flexible Filament brace/adaptor for Malyan M180

This is a simple part to fill the gap between the rollers and the top of the extruder tube on the Malyan M180. This will help to hold flexible filament in place and will make it less likely to buckle.

Note that it's not perfect! I still had some issues with the filament buckling, but it reduced the occurrence by about 90%. Without the brace it would buckle frequently even at 10% speed and was unusable at 20% or faster; with the brace I was able to run it at normal (100%) speed with far fewer buckles.

I found it started to get chewed by the wheel after a few hours' use. It's probably best to print a few at a time just in case! It only takes a couple of minutes to print and uses a few cm of filament.

To install:
You will need to remove the existing filament and pass the end through the brace and into the extruder tube The brace is not symmetrical - the smaller indentation faces toward the motor.