Neato Botvac Connected Swiffer Adapter

Wet mop adapter for the Neato Botvac Connected. Two parts.

STATUS: First print worked eventually, but there is a geometry error in the two outer struts of the top part (missing faces). The longer pins on the successful print did not slide all the way into their intended receptacle on the bot (either the hole is not fully cylindrical or the placement is off by a mm). Cutting off a centimeter solved that, also no magnets necessary to hold it in place. Notes for the next version: shorten the long pins by a centimeter, move the small pins a millimeter further out to better align with the holes, and ideally move the second and fourth strut a bit inward as they are above the tiny wheels on the bot.

Based on a previous design for a Neato XV, just with the pins moved to the right positions for the Connected. It's also slightly less wide, less than 25cm, so it should print on a 10x8 inch bed.