Makerbot 5G Smart Extruder Hugger

I don't know if this would classify as a Remix or a new design. There is already a 5G clip on Thingaverse but I felt the need to print out two clips to "feel" secured, so instead of printing two clips every time they wore out, I designed this hugger.

This pretty much defeats the purpose of the Smart Extruder's magnetic mount, but as I've ready someone say, "I've had so many jams and had to open up the extruder so many times, the tabs are gone". These were my sentiments exactly. I have two original Smart Extruders that are friction-fit (by the components) and I'm now starting to get Extruder Detached errors, so these clips are now a necessity. Or, buy a couple Smart Extruder+ for $300 each.

There's nothing really special to note here. There is an opening for the hot air from the heat sink to escape, maybe I can design one with a 40-60mm fan for better extraction, so there is no blockage. The 4 fingers clip in the the usual places. The upper right finger is shaved for better access to the tensioner, Otherwise, that;s about it.

I like to print these with carbon fiber for a stiffer part, as well as longevity. I believe the CF-PLA will withstand more heat than regular PLA. I've designed some LED light rails for my 5G, and after about 2-3 weeks, they've curled, so I'm running on CF-PLA versions and they seem ok so far.

I like the feel of 3 shells and 15-20% infill on these parts. Print with supports. I printed it upright and it took forever and the supports were a little challenging to clean up. Maybe this would be better printed on its back, with only a small amount of support material for the four hooks.

I hope this helps all you 5G owners.