IKEA LACK ENCLOSURE V1

Check out Version 2 here: https://www.thingiverse.com/thing:2776584
This includes a 3,4,5 & 6mm version of the setup with a slightliy increased internal floor space and a variety of heights to fit your printer.

Version 1 - Below:

If you print it out please remember to share your make. It's always good to how other people have used the models :) Thanks!

Looking for something specific? Use the contents section on the left to navigate around. If you spot any errors in this post please let me know and I'll update.

This is a remix of the model made here http://www.thingiverse.com/thing:2012384

I loved this model due to the simplicity of the removable top. Since I wanted side panels I modified the design slightly to accommodate this while still allowing you to remove the top in one piece. So once you remove the filament you can just lift off the top table with the plexiglass attached.

Features

• Designed for 4mm plexiglass
• Allows for printer height of 460mm, 490mm or 500mm
• Removable top as one piece including the plexiglass.
• Tabs to support plexiglass on each side. These are a push fit to clamp the glass to the top table.
• I wanted to keep the design simple and maximize access so opted to leave out door hinges. Instead I have gone for a removable front panel that just slides into the tabs at the base and assuming you cut the plexiglass the right size is a snug fit when closing (no door catch required - I'll see if this lasts over time)