Modular DJI OSMO Stand (UPDATED) (Remixed)

I did some mesh cleanup on the center piece. Added rounding on the top inner edge to make inserting the Osmo easier and to prevent scratches on the Osmo. Also added edge beveling on the base of the center support and on the edges of the leg bases where they join the body to give it a bit of a finished look.

I re-made the legs from scratch. The original legs were not completely square. I also added cutouts to reduce material and lighten them which should reduce print time as well.

I added 2 new legs with a 3 degree cant to them. This stand is nice if the surface is flat. Rarely the case though. By using a cant on the legs, the surface contact points are only out on the tips of the legs and not the whole bottom surface of the stand. I didn't do a cant on the z-axis leg.