Wanhao Heated Bed Spring Guides

EDIT: Added a real life photo of them (quick and dirty print), and the directions below. I recently got myself a brand new Wanaho Duplicator i3 PLUS, and was looking around the web for things to do with it... that's when I found it: The dreaded RECALL! It seems that the springs between the heated bed and its support will rub the insulator off the board, which in turn can cause a short, or other nastiness. You really only need four to fix the problem, but why not install 8 (one on the top and bottom of each spring), to keep your springs straight up and down? 9 are included on this STL just in case one doesn't print correctly. Safety first, all! Directions: 1. Print this .stl 2. After your bed has cooled, power off, unplug, and remove all cables from the printer. 3. Grab a T8 scredriver and a pair of pliers. 4. Completely remove the thumbscrews from the bottom of the mounting plate. 5. Lift the heated bed off the mounting plate, being careful not to damage the wires connected between the mounting plate and the heated bed. 6. Remove the springs and set them in a safe place. 7. Use the pliers to hold the nut (if there is one) which is underneath the heated bed. Use the T8 screwdriver to unscrew the screw and remove the nut. 8. Slide one of the guides you just printed onto the screw, then replace the nut you just took off. If there was an insulating washer there, it's your choice to leave it or remove it (I removed mine.) Make sure the nut is nice and snug. 9. Replace the spring and put another guide on the bottom of it. 10. Do the same thing to the other three corners. 11. Replace the thumbscrews. 12. Re-level your bed. (I usually do this twice to three times to get it just perfect.) 13. ... 14. PROFIT!