Nerf Rival Apollo Pump Conversion and stock

Hello everyone,

I decided to release my design to the world. Here is my take on the Nerf Apollo Pump conversion, after looking online at a few different 3d printed Nerf Apollo pump conversions, I decided to take tidbits of each that I liked and compile them into my own design. This whole design and build are a work in progress and I have not tested this set up in a Nerf War yet. I have printed out a previous iteration of the design, of which you can see the attached pictures of. The design hasn't changed too much since that iteration. Make sure to set up your slicer to print in the best way you know possible to reduce supports and bed adhesion. Experiment/print at your own risk!

I have also designed a stock attachment. Please excuse the tape on the stock, I printed them in two pieces then epoxied puttied together because I was testing fit.

I appreciate any feedback/comments!

Please feel free to tip me or donate to me for the work on this design if you are so inclined to do so. Paypal: paypal.me/counterstrikegamer44

Additional hardware (that I used):
(2) 11"-11.5" long 0.5" wide metal flatbar (Can find at any hardware store, cut down to size at home. I used steel but aluminum will probably work)
(5) M6 x 1.00 x 50mm Hex Head Bolts
(5) M6 x 1.00mm Hex Nuts
(10) #6 Flat Washer
(1) M3 x 30mm bolt (For barrel to picatinny attachment)
(2) M3 Hex Nut (For barrel to picatinny attachment)

When I designed this, it was designed with horrible design intent and references. It's a mess. But here you go!

Some of the files:

Apollo Stock orginal https://a360.co/2Gr1Dom
Apollo Stock v2 https://a360.co/2pXoWuY
Assembly: http://a360.co/2qA9LK0
Picatinny: https://a360.co/2JaIJji
priming cap: https://a360.co/2JbfFbF