S.T.E.V.E E3DV6 Bowden Mount

Since I had plans to use a bowden setup with CompRevTech's S.T.E.V.E printer I made these parts that bolts on the extruder mounting plate.
there are 4 versions:

1. normal without a radial fan setup and no mount for a 12mm inductive sensor.
2. normal with a mount for a 12mm inductive sensor.
3. Radial 1 setup for usage of a radial fan and shroud from the Hypercube by Tech2c
4. Radial 2 setup is the same as above, only difference is that it includes a 12mm holder for a inductive sensor aswell.

version 1 and 2 moves the extruder a little further out compared to the Titan Extruder setup.
Version 3 and 4 moves it even further (10mm more than the version 1 and 2) due to the ducting.
Version 1 allows for usage of the dual fan setup as designed by CompRevTech.
Version 2 is limited to only one fan of the left side due to the inductive sensor setup.

You can use the clamp that Tech2C designed: https://www.thingiverse.com/thing:1752766
(E3D_clamp)

Mounting hardware for Version 1 and 2:
4x M3x10mm with 4x M3 nuts
2x M3x16mm with 2x M3 nuts (for the clamp)

Mounting hardware for Version 3 and 4:
4x M3x10mm with 4x M3 nuts
2x M3x16mm with 2x M3 nuts (for the clamp)
1x M3x20mm with 1x M3 nut (nut not realy required but can be usefull) for the fan
2x M3x8mm for the duct.