Working on 3d printable versions of the RC4WD parts for their 1/18 Gelande D90 truck, along with a few additional parts
SHARE YOUR MAKES!
5/30/17
- Added Dual motor mount (tested correct but may need a little trimming to fit)
- Added Riser bumpers, (slots cutout for 8mm magnet insert, to mount body with magnets!)
- Corrected Tire cover to be all caps.
6/1/17
- Added a thicker rear bumper as the first one was pretty flush with the body.
- added a untested Bumper + brush bar. I may break this into two printable pieces.
6/7/17
- added a new front bumper that should fit with the lifted body.
- Added rock "rock sliders" that should fit the body lift. and possibly stock when flipped.
- Added snorkel
6/20/17
- Added alternative lifted rear bumper
- Added THICK rear lifted bumper
- Added lift front bumper without winch
- added a untested no lift bolt on front bumper (you'll need LONG screws for this!)
- Added Offroad style rear bumper
- Added a thicker bodylift version of the rock sliders
- Added a solid Bodylift version of rock Sliders
- Added Solid spare tire for easier printing.
- REMOVED original front bumper, it didn't fit correctly.
As always! post a comment with issues or suggestions!
Intashu
