XBOX ONE Thumbstick Controller Extension

Version 3 (XBOX ONE ONLY) https://www.thingiverse.com/thing:2999403

Version 2 (XBOX ONE / 360 and PS4!!!) (My Personal Favorite) https://www.thingiverse.com/thing:2815021

Thumb Sticks for your XBOX ONE Controllers. One length does not work for all. I've created these to go from a 4mm raise in height all the way to 16mm. I like the 6-10mm range myself.

Been working on this design for quite a while and believe this to be a very usable Thumb Stick. The hole down the middle not only saves on material and print time but it actually really helps in the fit of your thumb. The model also includes a designed in support that should make printing easier. You just twist that out after the print is done.

The Thumb Sticks just press on your controller and has a very firm grip. I have not had one come off during gaming yet.

I've tested it, and a lot of other versions of it..., and you should have a full range of motion and can still depress the stick down at any spot. NOTE: I did have one controller that at the very top of the left stick it did seem to stop it from depressing, but when I removed the Thumb Stick and tried the controller in the same position it still wouldn't depress. So just be aware it could be the controller also.

PLEASE take the time to look at the print settings. This design does not have a lot sticking to the bed. So learn from my many hours of failures and tuning the design and the print settings.

 If you print and use one of these on your controllers and like it, Please come back   and give it a LIKE and show the MADE here also.