Bearing Holder 10mm & 12mm

Bearing Housing for- 10mm & 12mm Linear Bearings- ( SCS-UU )

Bearing Position & Mounting Holes are in the same place as the Aluminium Housings,,, they are designed to Reduce the weight of the MainBed,,,

Square M3 Nuts are used on both the 10mm & 12m and theirs a Hex Nut Version for the 12mm --

Mounting holes are 3mm Diameter,,

The parts fit together perfectly – they have a 0.2mm offset and the corners have been recessed so Corner swell is not a problem a 0.5mm Bevelled edge is on the Inside Clamp edge so first layer Flashing is not a problem either,,,– No clean-up or Very little is needed depending on your printing quality– they have been printed and tested a Dozen times

12mm or 1/2 Inch 4 gauge Pan Head screws should be used on the sides of the Bearing Holder but M3 Bolt or even Glue or Thermal Weld can be used and 3/8 inch or up to 10mm on the topside of the 10mm Version

---

There’s the bearing Spec Sheet which I used for a reference include with the download ---
Heat the 4-gauge Screw Tips with a flame for a clean thread cut,,
SketchUp Files is included for Mod work

-=Mindless=-