NodeMcu dish antenna

This is experimental high gain dish antenna which i maked for NodeMcu long range. I didnt printed it because i gived up on project, but im uploading it if anyone want to print it. I maked it 100% printable, altrough you probably should file up little bit of middle section for better fitting of NodeMcu. Its maked for original NodeMcu, altrough it will probably fit with chinesse clones.

You should print like this:
Dish part x8
Mounting plate x1
Middle dish part x1
Nodemcu holder and reciever antenna x1

Whole antenna is 263mm in diameter, but separate parts will fit 20x20 printbed. I managed to pack everything at once, altrough you should print parts separately, because of nozzle cloggings and stuff... For Dish part use skirt because it have really small printing surface. You should also use ABS if you plan to put it outside because ABS is better than PLA when it comes to sun heat.
-When you print dish, glue aluminium foil from inside to reflect wifi signal toward antenna.
-On NODEMCU small printed antenna put piece of wire around 50cm long and wrap it around long part of holder.

Use zipties, glue and tape as much as your instict tell you to. When you print it, send me some pictures, because i would really like to see it how it looks when its printed.

Happy printing and hacking!