Linear Bearing for 8mm Smooth Rod with 608 Bearings - Less Filament

Hallo everyone, this is a remix of the ZNahum`s Linear Bearing.

All sides are 6-8 mm too long, so i decided to make it smaller to use less filamet.
I also make a 30° Angel to use less Filament.

Use M8 x 25mm Screws and put them in from the Round side.
Use some washer left and right from the 608 Bearing.

Because there is just 1 Bearing on two sides, the Smooth Rod could move in any direction. That sometimes no problem but i want to make it more straight, so i added 3 Bearings in the second Version.

I haven`t printed it yet, but i think it should be everything ok.