CR-10 "Batfang" - Dual 50mm Fan Mod

This is a dual 50mm Fan mod for the Creality CR10 nicknamed the "Batfang."

It uses the stock hotend shroud, and press fits into place. It fits very snug at the current settings and does not move.

This fang has 3 parts, the body and two covers to reduce the support necessary for printing. It uses the 4 original screws from the stock part cooler to hold these covers on.

Please note that this upgrade is not recommended if you are going to be printing sequenced prints "one after another", as it adds significant mass to the print head, and will likely collide with parts on the hot bed if you do not print multiple prints "all at once."

If however you print single parts, or multiples "all at once" there should be no issues.

As of right now this is a working prototype. I have tested this part in a less "finished" state with the differences being in the corner radii (as you'll see in the images) and so far it has worked flawlessly.

I am sharing this in it's current state, hoping that the community will adapt and improve it as they see fit.

:) Happy Printing