8.5" Boogie Board Mount

Mount for the Boogie Board 8.5" LCD eWriter.

I've been using a Boogie Board for quite a while to keep track of misc data, leave notes about where and why I'm out of the office, etc for a long time. The problem is that the board tends to.... wander....

So to make it more usable (less prone to wandering), I designed a simple mount.

Basically, this mount allows the board to sit at 45 degrees on the edge of a piece of plywood, and it's secured by 2 small wood screws. My desk is made up of plywood 25mm thick, but I've included the SketchUp file in case you need to modify that.

Depending on your printer you may either have to file/sand the board clips to fit, or you could modify the file for a little more clearance. You could probably scale the file by 1 or 2 %, but that will also affect the plywood mount area as well.

I printed this in PETG, but that's only because I mostly print in that now. I suspect it would work just as well in PLA. I used 15% infill, 3 perimeters and 3 layers, but those are just my defaults.