Anet A2 Plus - Anet to Ramps 1.4 Conversion

Changes I had to make to use Ramps 1.4:
Change the endstop plug from 3 to 2 pin (I used jumper wires at the moment)
swap pins on the stepper motor to match ramps diagram (I'm horrible about removing pins without damaging them so I ordered replacement)
replace thermisistor connector with 2 pin jst connector
replaced anet lcd with smartcontroller lcd (probably didn't have to but I had already bought it before anet firmware was fully integrated into Marlin)

I will also try to gather any "things" that make this easier like the 2020 ramps mount etc...

update 2/13/2018 fixed issues in marlin and updated to 1.1.8
its setup for the smartgraphic lcd with sd support