GEPRC LX5 LSX5 Leopard FPV Camera and GoPro Session 5 Protector

This FPV camera protector for the GEPRC LX5/LSX5 Leopard and complementary GoPro mount is a bit of a Frankenstein. If you do not need the GoPro mount, I recommend the thing by Zytra (linked below), as it is what I used for inspiration and validation of measurements.

Things exist that combine the GoPro mount and FPVcamera protector as 1 thing, but I wanted to be able to use different materials for each part, interchange different angles individually if I wanted, as well as not lose any strength. I designed this such that the GoPro mount fully attaches to the top standoff and the FPV camera protector sits on top of/outside of the GoPro mount. It all goes together securely to my satisfaction. You'll need 1 additional 20mm round standoff for the rear of the GoPro mount. Additionally, I wanted to be able to swap the GoPro in and out of the mount easily, so I added slots for securing the front of the mount with zip ties. Otherwise, it is a bear to insert or remove.

I expect the FPV camera protector works best with the side plates I remixed.

I used several things as inspiration and measurement validation, but all objects were built new. The key piece that helped me was the Fusion360 source file linked by joem_ in his Session mount thing. This provided an accurate model of the metal pod for the LX5 to build from.

Credits:
GEPRC GEP-LX5 Leopard GoPro Session AND Runcam 3 mount (Works with LX4 LX6 LXS) by joem_

GEPRC LX5 "Leopard" FPV Camera Protector/Mount by Zytra

GoPro Session Protector / Cover with Strap Slots by Airmaxx23

I've included the Sketchup file should anyone wish to modify this further.

###Settings
Printer: Qidi Tech 1 V2

###FPV Protector Settings
Material: ABS
Supports: Yes - I manually placed supports in Simplify 3D in all the holes
Rafts: No
Resolution: .2mm
Infill: 50%
Perimeters: 4
Bottom Layers: 3
Top Layers: 3
Orientation: Print on its side

###GoPro Camera Protector
Material: Sainsmart TPU
Supports: Yes - I manually placed supports in all holes around the camera. I did not use supports in the standoff holes
Rafts: No
Resolution: .2mm
Infill: 50%
Perimeters: 2
Bottom Layers: 3
Top Layers: 3
Orientation: Print on its back (should load in the correct orientation)