manta2017 RG65 RC sailboat

UPDATE 2018-03-11: Added extra large mastbox, for 53 mm long fin.

UPDATE 2018-01-21: Added Hull_Complete files for those who want to adjust to their printer's Z height
Added hatch cover cutting templates

UPDATE 2017-12-05: Added _RevA keel molds: All parts 200 mm long now ;)

UPDATE 2017-11-16: Added readme.

UPDATE 2017-11-11: Added swingrig cross. Sorry, forgot about that one ;)

UPDATE 2017-11-05: All RevB files: Reduced width of foredeck openings so that patches are easier to apply.

UPDATE 2017-11-01: Added m17_Mastbox_universal and m17_midship_universal. This will allow to fit other keel fins than the one from the m17 mold. The universal mastbox will still fit the "normal" midship, but it needs to be aligned for verticality then. See picture for dimensions.

Andreas Hoffmann's manta2017 RG65 design, same design as Euro Open 2017 winner Huub Gillisen sailed. See http://rg-andy.blogspot.com/p/andydesign.html
Ready to sail approx. 900 g with DF65 bulb.
To be printed as single layer spiral vase hull in 0.55 mm wall thickness. Three section hull, stern and midship approx. 200 mm high, bow 253 mm.
NOTE: 4 section version for 200 mm Z height printers added.
UPDATED all _RevA parts: Corrected position of eyes for DF rig (was off by 9 mm).
A 70 mm cardboard tube cap fits the hatch ring.
Front mast position for swingrig, rear for conventional/DF65 rig. Use iglidur JSM 0608-043 for upper bearing and JSM 0405-04 for lower bearing.
Report in German RG65 forum: http://www.forum.rg-65.de/viewtopic.php?f=24&t=2071