Electronics Breadboard

I was reading through some of the forums and discussions regarding different ways to build PCBs. I started thinking about the midway point and had the idea to build a breadboard.

I ran up a quick block of 20 rows (no power rails for this test).

I've left a Slot under each row 10mm deep this is where a strip of metal is put in to form the contact.

This is an experiment I intend to print when I have a bot.

Primary design concerns are:

• Will it print cleanly enough for use?
• Has enough space been left for the metal contact strip?
• What strip type would work best?

I've included the SKP file.

NOTE: IF this works, selecting metal strips out of metal that will take solder would mean that the board could be turned over and components soldered into it to make it permanent. And then you could just print another one!