October 25, 2017
Description
I couldn't find a minimal screwless frame for my Raspberry Pi 3 so I created my own.
I've designed the pins being slightly wider at the top to hold the Raspberry Pi in place. This worked well on my print. Please test your own prints to make sure the Raspberry Pi is secure.
The dip under the SD card holder is 0.4mm thick. I printed at 0.2mm layer height or less so I had at least 2 layers there.
It took around 25 minutes to print.
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
MrPeter
