December 11, 2017
Description
This is a Christmas tree ornament I designed to be printed in VASE MODE.
Because it was designed to be printed in vase mode, there was no way to create a loop to hang it. To hang the ornament, heat the top of the ornament and bend it around to make a small loop.
Also, if you would like to illuminate the ornament, drill an appropriate sized hole in the bottom (10mm or 3/8" or so should be sufficient).
Please post your makes and comments! Don't forget to check out my other creations at https://www.thingiverse.com/mistertech/designs
License:
Creative Commons - Attribution - Non-Commercial