Airwolf HD2x Chimera Mount

this is my own design for a chimera with volcano hotends for the airwolf printer
there is an included back plate that you can use to attach something to as I did in the picture
You can print this without supports, the parts cooling fan is a standard 30mm fan
with this design you do NOT need to print any other parts, extend the legs/arms to trip the end stops it is 100% interchangeable with the airwolf hotend . I used the 4mm adjustment screw from my stock hotend on this unit but you can just get a 4mm screw and nut that is at least 20mm long to use if you dont want to take it from the stock unit. Once you use this you will never go back, I promise.
there is a hole next to the parts cooling fan I used the stock ptfe tubing put it thru the hole then placed a washer over a 4mm bolt and threaded it into the stock tubing this gave me something to run the wires to the back of the printer without putting extra weight on the 1.75mm ptfe tubing. You can do it however you want of course

As always I accept tips