Slim Wallet V1.2

My take on "The Slim Wallet by Pentland_Designs"

Changes that i can think of:
-the money clip is detachable (you can attach it to either top or the bottom side)
-card browser is a little bit changed. new design allows you to see the card with less effort.
-lock mechanism has changed. it works but it locks too tight, i will work on it to make it easier to open yet still safe.
-you can either print the "body and lock" stl or print them separately as "lock" and "body". if you print them together use supports, it may be tricky to break the supports that are inside but it's not that hard. if you print them separately print the lock with supports, clean it, then print body. it doesn't require supports but i really recommend rafts or brim. at around 75 mm z height put the lock mechanism in place, make sure that the lock is under the current print layer, then let it finish the print.

-i did around 10 protypes to fit my needs, and this is a successful model but still not perfect. i will keep updating it.

******It holds 7 cards +1 on the outside. if you don't fit all the slots(except for the outer slot) the lock mechanism will not work properly. i will make a smaller iteration in the future.